Satlink Ws-6979 Software Upgrade [verified] Jun 2026

Satlink WS-6979 Satellite & Terrestrial TV Signal Meter - Sciteq

Turn off the Satlink WS-6979 entirely. Plug your prepared FAT32 USB flash drive into the USB port located on the side or bottom panel of the unit. Step 2: Navigate the Main Menu

Select as your upgrade mode. Locate your firmware file from the list, select it, and press OK to begin the flashing process. Step 5: Reboot and Reset Satlink Ws-6979 Software Upgrade

Upgrading the software on your Satlink WS-6979 combo meter is

To successfully perform the upgrade, the following hardware and software components are required: Satlink WS-6979 Satellite & Terrestrial TV Signal Meter

Follow these steps precisely to execute the firmware flash via the USB port. Step 1: Download the Firmware

Firmware upgrading carries a risk of bricking the device if done incorrectly or if power is lost. Ensure you have a stable power source. This guide is for informational purposes. Always confirm the correct firmware version with your supplier. Locate your firmware file from the list, select

Download the correct software version from the manufacturer or a trusted satellite forum.

Download the latest firmware file (usually a .bin or .ssu file) from an authorized distributor or the manufacturer's support portal.

If the progress bar hasn't started, power cycle the device. If it freezes during writing, contact an authorized service center. Post-Upgrade Best Practices