Iridium-tipped for long life and consistent ignition under high-compression loads. Replacement Interval: Every 100,000 km (60,000 miles). 3. Critical Mechanical Torque Specifications
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
The sole source of propulsion for the front wheels. AWD models include an additional rear motor (MM48).
The genuine Nissan workshop manual is the gold standard for service information. For the E13 engine, this is the official , a 181-page manual published in 1981 by Nissan Motor Co. itself. nissan e13 engine service manual
The Nissan E13 engine service manual is a comprehensive, factory-level document. If you’re working on a vehicle with the 1.3L turbocharged HR13DDT engine (used in many Nissan/Renault platforms), this manual is — not optional.
Check regularly; standard intervals for 1980s engines are typically every 3,000–5,000 miles. Replace every 40,000 km to prevent internal corrosion. Brake Fluid: Replace every 20,000 km. www-asia.nissan-cdn.net Service & Repair Data Cylinder Head Torque:
9.0:1 (Typically, varying slightly by region and emissions gear) Fuel System: Downdraft Carburetor 2. Essential Maintenance and Tune-Up Procedures Iridium-tipped for long life and consistent ignition under
to shut down the control electronics.
From FL-18:
| Fluid | Capacity (L) | Spec | |-------|--------------|------| | Engine oil (with filter) | 3.3 – 3.5 | 0W-20 or 5W-30 ILSAC GF-6 | | Coolant | 4.2 | Nissan Blue L250 premixed | | Manual transmission (if equipped) | 2.0 | 75W-80 GL-4 | | CVT (if applicable) | 4.5 – 5.0 | Nissan NS-3 | Can’t copy the link right now
If adjustments are needed, loosen the locknut, turn the adjusting screw until the feeler gauge slides with a slight drag, and lock the nut back down.
What is your vehicle experiencing (e.g., misfiring, overheating, low compression)? Are you working on a carbureted or fuel-injected variant?
Keep this table printed in your workshop: