L1 --> Stop Button --> Start Button --> Contactor Coil A1 Contactor Coil A2 --> 95 (Overload NC) --> 96 --> Neutral
The is a microprocessor-controlled automatic transfer unit designed for managing stand-by generating sets. It monitors both the three-phase mains supply and the single-phase generator to ensure seamless power switching during anomalies. Core Technical Specifications
The time the controller waits after a power failure before starting the engine (to avoid "nuisance starts" during momentary flickers).
Ensure the external E-Stop button is not engaged. lovato 31 rgam 12 user manual
Equipped with a 3-digit LED display and a front keypad for manual parameter programming without needing external tools. Durability:
: Typically involves holding the RESET key while following a specific button sequence (e.g., START x2, STOP x3, MEAS x4) to enter "SET" mode.
The 31 RGAM 12 can operate in four distinct modes, selectable via the front keys. This allows you to use the unit in fully automatic or manual configurations. L1 --> Stop Button --> Start Button -->
Dedicated RS-232 serial port standard on the base model.
: Includes programmable pre-heating (glow plugs) and multiple starting attempts with set intervals.
The RGAM 12 interface is designed for simplicity. It usually features three primary modes: Ensure the external E-Stop button is not engaged
Meets standard IEC/EN 60255-6, EN 50081-1/2, and EN 50062-1/2. 2. Technical Specifications
The user interface balances simple operation with comprehensive diagnostic information. Operational Modes
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.