For the full detailed document, you can access the Probo PR70/120 Installation & Maintenance PDF from Montaza or the Spanish/English Manual from Zarko Comunicaciones. How to program Probo XL
| Control | Function | |---------|----------| | | Master ON/OFF | | Pressure Dial | Adjust output (70–120 PSI) | | Prime Button | Purges air before use | | LED Status (Green) | Ready | | LED Status (Yellow) | Overheat / Cooling | | LED Status (Red) | Error / Check manual | For the full detailed document, you can access
End of 10-page manual.
Use a spirit level to verify that the runner rail is completely straight and level across its entire horizontal run. Tighten all front and rear bracket assembly screws firmly. Page 5: Door Attachment & Geometry Control Tighten all front and rear bracket assembly screws firmly
: Lift the operator and insert its splined protruding drive shaft directly into the drive receiving block hole on the pre-assembled runner rail. Do not force or misalign the keyway tab. Regularly test the obstruction sensitivity
Regularly test the obstruction sensitivity. If the door meets an obstacle, it should stop and reverse immediately. 6. Safety Warnings This product is for professional installation only.
Secure the operator using the provided hexagonal-headed screws and brackets Peiter Automatic Mechanical Stops Closing Stop
