Hyt Tc580 Programming Software New 'link' Jun 2026

Input your authorized UHF or VHF frequencies. Ensure you conform to narrow-banding rules (12.5 kHz spacing) if required by local regulations.

This is usually a COM port mismatch. Ensure the software is set to the same COM port shown in your Device Manager.

Connect the 2-pin end of the programming cable securely into the speaker/microphone jack on the side of the radio. Turn the volume/power knob clockwise to . Reading Data from the Radio

Always back up your radio's factory settings before making changes. In the CPS interface, click on > Communication Port . hyt tc580 programming software new

Disclaimer: Ensure you possess the appropriate licenses for your radio frequencies as required by local regulations.

Click the icon on the toolbar (or navigate to Program > Read Data from Radio ).

Most programming cables utilize a Prolific or FTDI chip to convert USB signals to serial data. Input your authorized UHF or VHF frequencies

Click "Write to Radio" to upload the new configuration. Troubleshooting Common Issues

Always click "Read" before making changes. This creates a backup of the current factory settings.

He had called HYT support. A bored tech had said, “We have a legacy patch, but it’s unstable.” Ensure the software is set to the same

The TC580 uses a standard 2-pin Hytera/Kenwood style connector. For the best results, use a cable with an FTDI chip , as these are "plug-and-play" and avoid the driver headaches associated with cheaper clones.

Click the icon on the toolbar (or navigate to Program > Read from Radio ).