Fanuc Wn57 Override Function Is Active |link| 〈480p〉

The of your FANUC control (e.g., 0i-TF, 31i-B)? Whether your machine is connected to a robot or bar feeder ?

Observe the CNC status screen to see if the warning clears instantly. Step 2: Check the CNC Status Monitor Press the (Position) or MDI key on the FANUC MDI panel.

| Function | FANUC Signal Name | Typical Address | | :--- | :--- | :--- | | Machine Lock 1 | G104.0 | G116.0 (older) | | Dry Run | G104.7 | G116.7 | | Aux Funct Lock | G104.1 | N/A | | Handle Interrupt Mode | Input from rotary switch | Varies | fanuc wn57 override function is active

After setting all overrides to 100%, press the RESET button to clear the message.

The override function enables the following capabilities: The of your FANUC control (e

Verify that your Rapid Override (RT) and Feedrate Override dials are set to standard production percentages (e.g., 100%) and are not stuck between detents. Step 2: Verify Robot / Automation Status If your machine uses automation:

To disable through setting parameters:

Switch to or MEM mode and check the current active G-code modal list.

Overriding normal signal processing can bypass safety interlocks and protective features. Step 2: Check the CNC Status Monitor Press

: If a technician was recently working on the machine, they may have used the Forced I/O function in the PMC to override a signal. Per the Fanuc 30i/31i/32i Handbook , an "Override Mode" of the forced I/O can be active for up to three paths simultaneously.

Look for override neglect codes like or specific macro calls.