Everstart Battery Charger 60108m Manual Fix [OFFICIAL]

: Prevents damage if clamps are connected to the wrong terminals. Troubleshooting Battery Not Detected

If the charger keeps entering "recondition" mode, it may be necessary to leave it connected for the full 24-hour cycle to properly treat the battery.

Never allow the positive (red) and negative (black) clamps to touch each other while the charger is plugged in. everstart battery charger 60108m manual

Never operate the charger if the power cord or plug is damaged. Connect the power cord only after the clamps are securely attached to the battery. Understanding the Control Panel & Specifications

A slow, gentle trickle charge. This setting is ideal for small batteries (like those in motorcycles, lawnmowers, or ATVs) or for maintaining a full charge on a stored vehicle. : Prevents damage if clamps are connected to

Clean the battery terminals before hooking up the clamps. Avoid letting corrosion come into contact with your eyes or skin.

Connect the clamp to a heavy, unpainted metal part of the engine block or frame, far away from the battery and fuel lines. Step 3: Select Your Settings and Plug In Never operate the charger if the power cord

| Problem | Possible Cause(s) | Solution(s) | | :--- | :--- | :--- | | | No power at the outlet; faulty AC cord; internal fuse blown. | Check the outlet with another device; inspect the power cord for damage. | | LCD screen is blank or white | Internal electronic failure. | This is a known issue reported by some users. Try disconnecting all power and reconnecting. If the problem persists, the unit may be defective. | | Charger stops working after a few minutes | Overheating; internal fault; poor connection. | Ensure the charger is not in direct sunlight or near a heat source. Check all connections. If the problem continues, the charger may have a defect. | | "Reverse Polarity" error | Battery clamps are connected to the wrong terminals. | Immediately disconnect the charger. Reconnect the RED clamp to (+) and the BLACK clamp to (-). | | Charger stops and starts intermittently | Loose connection; faulty internal component. | Check the clamps and the battery posts for corrosion. Clean them if necessary. If the issue persists, the charger may be failing. | | Battery doesn't hold a charge | The battery itself is old, sulfated, or has a dead cell; incorrect charging settings. | Use the reconditioning function if available. If the battery continues to fail, it may need to be tested at an auto parts store for replacement. |

Best for maintaining a battery or slow charging to prolong life.

If your vehicle will not crank, the 200-amp engine start mode can assist your battery. Connect the clamps according to the standard safety steps. Set the selector switch to . Plug in the charger. Crank the engine for no more than 3 to 5 seconds .