Din En 13155 Pdf Exclusive -

Testing all safety mechanisms, including low-pressure sensors on vacuum lifters and battery warning indicators on magnetic lifters. Documentation, Marking, and Traceability

DIN EN 13155 is the harmonized European safety standard for non-fixed load lifting attachments, defining mandatory design and testing requirements for equipment like plate clamps and vacuum lifters. The 2020 revision (EN 13155:2020+A1:2025) introduced updated verification methods, including "Test Only" and "Calculation plus Test" pathways to ensure safety factors. For a full overview, including safety requirements, visit iTeh Standards iTeh Standards SIST EN 13155:2021/oprA1:2023 - iTeh Standards

The documentation details design and safety mandates for eight specific attachment categories:

Every certified lifting attachment must be permanently marked with the following information: The manufacturer's name and address The (and UKCA where applicable) The year of manufacture The serial number or unique identification code The Working Load Limit (WLL) in kilograms or tonnes din en 13155 pdf exclusive

The standard requires a high structural safety margin to account for dynamic forces (such as sudden stops or jerks during lifting).

DIN EN 13155 PDF Exclusive: The Ultimate Guide to Non-Fixed Load Lifting Attachments Safety

: Mechanical friction-grip devices used to lift vertical or horizontal metal sheets safely. For a full overview, including safety requirements, visit

Unlike fixed crane hooks or permanent magnets, this standard covers attachments that are:

A: DIN EN 13155 covers the safety requirements for cranes, hoists, and their associated components.

The standard is the benchmark for pre-use inspections and periodic thorough examinations. It provides criteria for identifying wear, deformation, or damage, forms the basis for operator training regarding safe working loads and hazards, and is the authoritative source for safe operating procedures (SOPs). The standard is the benchmark for pre-use inspections

Which of the standard your project requires?

Here's a review of the standard, exclusively for you:

The dead weight of the attachment itself (if it exceeds 5% of the WLL or 50 kg) Accompanying Documentation