Cwfl-6000 Manual Review

Connect the "Inlet" of the chiller to the "Outlet" of your fiber laser source, and vice versa.

Water flow alarm. Usually caused by a kinked hose, low water level, or a clogged pump filter. E7: Water temperature sensor failure. 6. Safety Precautions

Locate parameter to set your desired temperature target if using Constant Mode (recommended laser target is usually 25°C ). Press the "RST" (Reset/Exit) button to save and exit. ⚠️ Section 4: Alarm Codes & Troubleshooting cwfl-6000 manual

). Following the CWFL-6000 User Manual ensures the longevity of both the chiller and the expensive fiber laser it protects. Key Specifications Summary Specification Up to 14.5kW Control Precision Water Tank Volume Approx. 40L Refrigerant

Press to navigate through parameters. Look for parameter F0 (Control Mode). Change F0 from 1 (Intelligent) to 0 (Constant). Connect the "Inlet" of the chiller to the

Connects to the laser cutting head / optics system. 🕹️ Section 3: Smart Temperature Controller Operation

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. E7: Water temperature sensor failure

By default, the chiller is set to , which adjusts the water temperature automatically based on changes in the ambient temperature to prevent condensation.

Keep the unit in a well-ventilated, dry indoor environment. Avoid direct sunlight, corrosive gases, and extreme dust. Operating ambient temperature should ideally be under 40°C. Electrical Connections

Since S&A (TEYU) updates their manuals frequently, you can obtain the official PDF by:

: Critical warnings regarding high voltage and refrigerant handling. Installation