Bystronic Laser Error Code List //top\\ -

Power down the machine for 10 minutes to reset the thermal overloads. Inspect the motor power cables for breaks or shielding wear. Step-by-Step Emergency Troubleshooting Protocol

Ambient temperature stays within the recommended operating range. Step 4: Inspect Consumables and Optics

Opens a context-sensitive help page for the active view or dialog. System Messages:

Low oil in the Y-axis system; check level and lubrication switches. 700632 - 700636 Mirror Not Closed bystronic laser error code list

The system shuts down within minutes of turning on the resonator.

Triggered when the laser gas (CO2, Nitrogen, Helium mix) deviates from the required barometric pressure. Indicates empty gas cylinders, leaking supply lines, or faulty gas mixers.

: System software/firmware version is outdated and requires an upgrade. Power down the machine for 10 minutes to

: The X, Y, or Z axis moved past its safe working zone. Manually jog the machine back into the cutting area.

The laser fails to form a beam or shuts down mid-cut.

Check the RF power supply module and cabling for power issues. Step 4: Inspect Consumables and Optics Opens a

Drain water from the blue valve located above the cutting head to purge air.

: Water flow through the cutting head or resonator dropped below safe levels. Clean the filters. Check for kinked hoses.

Temperature limits exceeded, flow rate drops, or pressure drops.